Durston Ring and Stock Bender with Die Pairs

Built with Durston’s award-winning design and engineering expertise, this ring bender set allows you to easily create curves and angles in ring sizing stock or metal strips up to 2mm (0.078") thick. The bending tool offers 11 shaped forming steel and non-marring Delrin® die pairs that are stored in an elevated marked tray that is above the bender on an attached pivoting post. Each tool steel die die is hardened to 52 HRC and is finely finished to reduce marring metal surfaces. The tray easily swings completely out of the way during use. If desired, the bender may be secured permanently to your bench using the holes conveniently cast into the base (hardware is not included). This set includes 20 dies: • Two sets (one steel, one Delrin®) of nine round dies: 8, 10, 12, 14, 16, 18, 20, 22, 24mm diameter • Two sets (one steel, one Delrin®) of two angled dies: 60° and 90°.